Název:	Study of power consumption of Timepix3 detector
Autoři:	Burian, Petr Broulím, Pavel Bergmann, Benedikt
Citace zdrojového dokumentu:	BURIAN, P., BROULÍM, P., BERGMANN, B. Study of power consumption of Timepix3 detector. Journal of Instrumentation, 2019, roč. 14, č. January, s. 0-10. ISSN 1748-0221.
Datum vydání:	2019
Nakladatel:	IOP Publishing
Typ dokumentu:	článek article
URI:	2-s2.0-85062558502 http://hdl.handle.net/11025/33948
ISSN:	1748-0221
Klíčová slova v dalším jazyce:	data acquisition concepts;detector control systems (detector and experiment monitoring and slow-control systems, architecture, hardware, algorithms, databases)
Abstrakt v dalším jazyce:	The Timepix3 readout chip - the latest member of the Medipix family of hybrid pixel detectors - brought several new functionalities in comparison with the older Timepix, i.e. a high hit-rate, a time granularity of 1.5625 ns, a data-driven readout scheme (with a per pixel dead time of approximately 475 ns), and the capability of measuring Time-over-Threshold (ToT) and Time-of-Arrival (ToA) in each pixel at the same time. However, the high power consumption of the Timepix3 in the standard setting prevents its use in applications with limited power budget. Moreover, the high power consumption poses the risk of overheating the sensor so that proper cooling is crucial. The presented work investigates the effect of different settings in the analogue and a digital part of the Timepix3 detector on its power consumption. Measurements were performed with the Timepix3 chipboard. The firmware of the Katherine readout was modified so that the user can monitor the power consumptions of analogue and digital part "on-line" (directly in the control software). In standard settings, a power consumption of approximately 1.3 W was found. By changes of internal DACs, the consumption could be reduced to 650 mW. Further reduction was achieved by the change of the clock management in the digital part of the Timepix3. In result, a power consumption of 216 mA could be achieved. In these low power settings, the ToA clock was reduced to 10 MHz and thus the time binning was 100 ns. The energy resolution was not affected significantly. The pixel dead time is also negatively affected when the matrix clock is reduced. In the case of 10 MHz, the minimal per pixel dead time is 1.9 mu s.
Práva:	Plný text je přístupný v rámci univerzity přihlášeným uživatelům. © IOP Publishing
Vyskytuje se v kolekcích:	Články / Articles (KAE) Články / Articles (RICE) OBD

Všechny záznamy v DSpace jsou chráněny autorskými právy, všechna práva vyhrazena.