The paper describes the possibilities of energy harvesting using thermoelectric generators. Because of very low output voltage thermoelectric generators need integration of large number of individual thermo-junctions. Printing technologies enhance effective production with individual junctions all connected in&...

This article is focused on comparison and testing of two different microsystems for an inertial navigation intended especially for places without GPS signal. These inertial navigation systems were compared with GPS system. The next research work was focused on dispersion detection from ...

The paper reports on the fabrication and characterization of low-cost electrodes for capacitive level sensors realized on a flexible substrate. The aim is to prepare conductive electrodes by printing of silver and PEDOT:PSS pastes on coated PET foil. Individual capacitors in the form&#x...

The work is focused on problematic of electrically conductive adhesives. These are used as an alternative to solder joints. Goal of work was concentrated to analysis of influence of curing conditions on electric and mechanical properties of electrically conductive adhesives. Samples of ...

This paper describes a Universal Synchronous and Asynchronous serial Receiver and Transmitter and its basic setting. Further it describes a divided Flash memory at ATmega chip. The function of the Bootloader and the storage in Flash memory is described too. Than it describes the&#x...

The article presents design and realization results of capacitive sensors realized on flexible substrates. Presented planar capacitive sensors were realized by standard polymer and ink-jet printing technologies at two different polymer substrates. Developed flexible planar capacitive sensors can be us...

The current load and its influence on degradation of Al-1%Si wires bonded onto copper pads is presented in this paper. The current load was chosen to occur the electromigration phenomenon during ageing. Our attention was paid to the direction of current from Cu pad to Al&...

This research deals with the issue of the thick-film technology. This work is focused especially on the trimming value of resistance thick-film resistors. The main aim is to use simulation program for resistance value prediction. The laser trimming is used to ensure accurate values...